Bell Reducers

ANSI/AWWA C153/A21.531 and AMERICAN Standard

Reducers can be furnished with Flex-Ring or Lok-Ring bells and Flex-Ring or Lok-Ring ends. The dimensions shown here are representative of bell-configured reducers for Flex-Ring and Lok-Ring. As such, some variation may occur. Consult AMERICAN for exact dimensions (including laying lengths in some cases) and weights if these are critical.

Plain ends on available reducers may or may not be beveled/smoothed for push-on joint assembly. If push-on assembly is required, such ends may require field bevel/smoothing. Also see Plain End.

2 1 4 1 7A Ft Reducers Print
Size
(in.)
Pressure Rating
(psi)2
Thickness in
Inches
Bell x Bell
Large End Small End T
Large End
T 1
Small End
L
Laying Length
(in.)
Weight
(lbs.)
54 30 250 0.90 1.00 31.25 2035
54 36 250 0.90 1.15 27.25 2180
54 42 250 0.90 1.25 19.25 1850
54 48 250 0.90 1.40 15.25 1890
60 30 250 0.94 1.00 35.5 2345
60 36 250 0.94 1.15 31.5 2505
60 42 250 0.94 1.25 23.5 2175
60 48 250 0.94 1.40 19.5 2230
60 54 250 0.94 0.90 10.25 1815
64 30 250 0.99 1.00 39.25 2690
64 36 250 0.99 1.15 35.25 2860
64 42 250 0.99 1.25 27.25 2525
64 48 250 0.99 1.40 23.25 2590
64 54 250 0.99 0.90 14.5 2145
64 60 250 0.99 0.94 10.25 2050
1.) AWWA C153 configurations with shorter center-to-socket dimensions, etc., may be furnished in some cases in the 18"-48" size range. Consult AMERICAN if dimensions are critical.
2.) Higher pressure ratings are available on special applications. Consult AMERICAN.
3.) 16" Flex-Ring fittings may have greater “T” and “T 1” dimensions than those shown.